S.R Enterprises

Product Brief

Strong yet lightweight composite material construction, evenly balanced design & compact profile make the GROZ impact wrenches ideal to get THE JOB DONE

Ideal for professionals who want the perfect blend of optimum performance & comfort of use.

Twin Hammer impact mechanism delivers balanced blows

3 speed position control to adjust tool speed for different applications in the forward direction

Full torque output in reverse direction

Rear handle exhaust with muffler directs air away from the job & operator, ensuring safety

Ideal for use in

• General automotive repair & service centers for passenger vehicles
• MRO jobs in railways
• Repair & maintenance of gear units & boxes
• Repair & maintenance of printing press machines

Power Control A regulator (Fig. 2) is provided to increase / decrease the power output. Turn the regulator to the position of smaller circle /number for the least power output and larger circle/number for highest power output.

INSTALLATION

Air Pressure Always use clean and dry air at 90 psi (6.2 bar) to operate the Pneumatic tools Do not operate Pneumatic tools beyond the maximum working air pressure of 90psi (6.2 bar).

Air Line

For using pneumatic tools efficiently, connect air hose to the air inlet. Compressed air has traces of moisture (water droplets) in it and this moisture may permeate into the pneumatic tools and cause mechanical failure, therefore It is strongly recommended to install an air filter, moisture separator, regulator and lubricator in the air supply line. Typical air supply setups are shown on the following pages. (Fig. 4: Portable Air supply Setup; Fig 5: Stationary air Supply Setup)

Air Hose

Before connecting the air hose to pneumatic tool, thoroughly clean the air hose with the blow out of compressed air. This will prevent both moisture and dust contained within the hose from entering the tool and causing possible rusting and malfunctioning.

OPERATION ON/OFF

Operation The trigger (Fig.
1) of the Groz pneumatic tools are designed either inside or outside of the grip. These are “plug-and-run” type devices. The pneumatic tool will stop operating in a few seconds after relieving the trigger

Rotation Direction

Be sure to check the rotation direction (Fig. 3) before operating the tool. The "F” indicates the forward direction of rotation and “R” indicates the reverse direction of rotation. Forward direction is defined as clockwise direction seen from the operator's position.

MAINTENANCE

Lubrication Every week clean the loader adaptor with a cloth to remove foreign particles so the pump is free of contamination.

Fastening of parts

Regularly check if all the connected parts are fastened securely

Cleaning

Dusty and oily surface on the handle will erode the protective grip of the tool, because of the reaction torque. Cleaning the grip with a dry cloth is highly recommended before and after operation.

Storage

Store the tool in dry and clean environment. If the pneumatic tool will not to be used for a period of time, the residual moisture inside of the pneumatic tool can cause rusting. Therefore before storing, oiling the pneumatic tool at air inlet with spindle oil and operating it for a short time at regular intervals is strongly recommended.

Repairs Always use Genuine Groz Spare parts for all service and repair. Do not modify, tamper or make any unnecessary/ temporary repairs to the pneumatic tools. All major service of maintenance and repairs should only be carried out by well-trained technician

We are offering Cordless Impact Wrench range of products to our clients.